Water pipes run deep into the ground. Recent building codes often call for two or more ground rods for added security.
The service panel ground wire must be firmly attached to the ground rod either with a special toothed clamp or by welding.
How to ground a wire in a house.
Attach the other end of the metal wire to the water tap or the pole.
A copper ground rod is driven at least 8 feet into the ground.
Run copper wire starting at the main electrical panel then out of the house and into.
Once gallant starts wiring a house virtually every aspect of his work is controlled by codes both local and national.
How to ground my house step 1.
Also make sure the pipes are free and clear of any paint rust.
Gallant is meticulous in adhering to them yet he often goes a step further to make his electrical systems even safer and easier to use.
Leave one bare ground wire long and snip the rest to 6 in.
How to ground an outlet grounding the receptacle attach the grounding wire to the grounding terminal.
Attaching the wire to the water tap is a better idea.
Its top may be visible or it may be sunk a few inches beneath the ground.
Run the wire around the house keeping it at least 10 feet away.
Attach the metal wire to the power box or the wires leading out of it.
These codes are the final word on safe installation practices.
Shut down the power to your house to avoid electrocution.
Do not install clamps near a union or elbow because the tightening of the clamps could break or weaken soldered joints.
Fold the ground wires neatly into the back of the box photo 11.
Install pipe ground clamps on each pipe hot water supply cold water supply gas roughly a foot above the water heater.
Connecting the ground wire to a metal electrical box will energize the box in the event of a short circuit.
Solder the copper wire to each rod with a soldering iron.
The box could overheat and start a fire or someone could get a shock from touching it.
Power tools vacuums and many other appliances are much safer when they have a third prong on the cord plug which is shaped to fit the round grounding slot on an outlet receptacle.
Turn the power back on.
Push the long wire through the hole in the top of the special green wire connector and connect the remaining wires to it by twisting the connector clockwise until its tight.
Drive the rods into the ground.
Dont rely on metal sheathing or an exposed ground wire.
Not only does your home wiring system have a grounding system for safety but many plug in appliances and devices do too.
No comments:
Post a Comment